Uwatec Galileo sol Technical Information download pdf (Page 55)

3. Diving with Galileo

53

English

- RBT

- time of day

- stopwatch

- active MB level

- temperature

- heart rate

- average depth

- max depth

- oxygen concentration

- nitrogen loading (via right bar graph)

- oxygen toxicity (via left bar graph)

Upon pressing the middle button (marked

MORE), the information in the left corner

changes in the following sequence:

- O

2

%

- buddy tank pressure (only if BUDDY

tank designation has been paired, see

section 1.11)

- (no-stop or decompression information

relative to L0 if an MB level between L1

and L5 is active, see section 3.5.3)

- CNS O

2

- ppO

2

Each time you press the button the

information changes to the next one in the

sequence and stays there until you press

the button again. If you press the button

while the ppO

2

is displayed, the cycle starts

again from the oxygen concentration.

The stopwatch is reset and restarted by

pressing the left button (BOOK).

3.4 Special functions

common to CLASSIC,

LIGHT and FULL

conﬁ gurations

3.4.1 Accessing and using the digital

compass

In all lay-outs, a press and hold of the right

button (marked LIGHT) brings up the digital

compass display on your computer screen.

The display also shows the depth, the dive

time, the tank pressure and the shortest

between the no-stop time and the RBT. In

case of level stops or decompression, the

lower right corner alternates every 4 seconds

between decompression information and

tank pressure together with RBT. A press

and hold of the right button from the

compass display returns to the computer

display. This also happens after the set auto-

off time deﬁ ned in section 2.4.2.



NOTE:

If you are in compass mode when

Galileo is about to end the no-stop

phase, the screen will revert to the

regular computer display regardless

of the set auto-off time. Press and

hold the right button again if you wish

to return to the compass display.

In this lay-out, the button functions change

slightly. The middle button is now marked

SET. Pressing this button will set the

bearing. Compass bearing represents

the direction the front of the computer is

pointed at. It is expressed in degrees, from

0 to 359. 0 degrees is North, 90 degrees is

East, 180 degrees is South, 270 degrees is

West and any other reading is interpolated in

between.

The message

SET BEARING SUCCESSFUL

will show on the display and a dot will appear

in the position of the set bearing. Setting a

bearing allows you to navigate towards a

reference direction. A press and hold of

the middle button will erase the set bearing.

Note that the set bearing stays in memory

until you either set a new one or erase it. All

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 79 80

Comments to this Manuals

No comments