Uwatec Aladin PRIME Technical Information download pdf (Page 41)

VIII Settings

VIII UWATEC

Aladin

dive computers

VIII

English

Switching the audible attention signals on and off

With this option you can switch off the audible attention signals only (the

audible alarms remain active). Refer to page 17 to see this distinction.

Confirm that you wish to change the setting of the audible attention signals

by pushing .

"On" or "off" starts to flash.

2. Switch between "on" or "off" by pressing .

3. Confirm the setting with .

Switching the water contacts on and off

On submerging in water the water contacts switch on Aladin

automatically

If you chose the option „Water contacts off“,

Aladin

will turn on with a delay of up to 1 minute

into the dive. This will affect functioning of the

computer.

Make sure that the computer is on before starting

the dive.

Confirm that you wish to change the setting of the water contacts by pushing

"On" or "off" starts to flash.

2. Switch between "on" or "off" by pressing .

3. Confirm the setting with .

Resetting the remaining saturation

Diving after a reset of the remaining saturation

may lead you into

potentially

hazardous situations

which could result in death or serious injury.

After a reset of the remaining saturation do not

dive for at least 48 hours.

If you dive after resetting the remaining saturation the computer will mis-

calculate your decompression, which may result in serious injury or death.

Reset the remaining saturation only if you know you will not be diving,

flying or going to higher altitude for the next 48 hours.

Resetting the desaturation should only be done when there is a valid reason,

e.g. loaning the computer to somebody who has not dived in 48 hours or

more. When the computer itself has remaining saturation you must assume full

responsibility for the consequences of resetting the remaining saturation.

Confirm that you wish to reset the displayed saturation by pushing .

"On" starts to flash.

2. Switch between "on" or "off" by pressing .

3. Confirm the setting with . If you have selected "off", "code" and

"000" appear.

Set the first digit by pushing and

. Confirm with

Repeat point 4 for the next 2 digits. If you entered the right code the desatu-

ration will be reset to zero (desat off)

Code: 313

WARNING

DESADESATT

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Uwatec Aladin PRIME Technical Information Page 41

Comments to this Manuals

Related products and manuals for PC/workstation barebones Uwatec Aladin PRIME