Uwatec Aladin PRIME Technical Information download pdf (Page 30)

V TEC Diving with microbubble levels (MB)

V UWATEC

Aladin

dive computers

The following chapter deals with the characteristics of diving with microbubble levels (MB level).

For general information about displays and features of diving with Aladin

TEC see chapter III.

Microbubbles are tiny bubbles that can build up inside a diver's body during any dive and normally dissipate

naturally during an ascent and on the surface after a dive. Dives within no-stop time and observance of decom-

pression stops do not prevent the formation of microbubbles in the venous blood circulation.

Dangerous microbubbles are those migrating into the arterial circulation. The reasons for the migration

from the venous blood circulation to the arterial circulation can be a great many microbubbles collecting in

the lungs. UWATEC has equipped

Aladin

dive computers with a new technology to protect from microbubbles.

The diver chooses – according to his/her needs – an MB level and influences through it the level of pro-

tection from microbubbles.

Diving with MB levels requires additional ascent stops (level stops), the ascent is slo-

wed down and the body gets more time to desaturate. This works contrary to the formation of the microbub-

bles and increases the safety

Aladin

TEC features 6 microbubble levels (L0-L5). Level L0 corresponds to UWATEC's well-known decom-

pression model ZH-L8 ADT and does not require level stops due to microbubble formation. Levels L1 to L5 offer

additional protection from microbubble formation with level L5 offering the highest protection.

Similar to the display of information during decompression dives or dives within no-stop time,

Aladin

TEC

displays depth and duration of the first level stop as well as the total time of ascent as soon as the MB no-

stop time has run out. As the MB no-stop time is shorter than the ordinary no-stop time a diver will be requi-

red to carry out a stop (level stop) sooner than a diver using level L0.

If a diver ignores a required level stop,

Aladin

TEC

will change over to a lower MB level and the dive can not be

completed with the initially chosen MB level. E.g. If a diver sets level L4 on

Aladin

TEC

prior to the dive and during

the dive ignores the stops recommended

Aladin

TEC

will automatically adjust the setting to level L3 or lower.

1 Comparison of dives with MB level L0 and MB level L5

When two Aladin

TEC are used simultaneously, one unit is set for example to MB level L5, the other to

L0, the no-stop time will be shortened and level stops will be required before the diver has the obligation

of a decompression stop. These additional level stops help dissipate the microbubbles.

NO STNO STOPOP

3m/10ft

6m/20ft

9m/30ft

12m/40ft

15m/50ft

Time

Depth

Microbubble accumulation

at the end of dive

Stop depth

Microbubble

level

NO STOPNO STOP

STOPSTOP

DECODECO

STOPSTOP

DECODECO

NO STNO STOPOP

Decompression values

Level stop values

Decompression obligation, ->33

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Comments to this Manuals

No comments

Uwatec Aladin PRIME Technical Information Page 30

Comments to this Manuals

Related products and manuals for PC/workstation barebones Uwatec Aladin PRIME