Uwatec Aladin 2G User Manual download pdf (Page 47)

English

IX Settings

IX UWATEC Aladin TEC 2G

Switching the audible attention signals on and off

With this option you can switch off the audible attention signals only (the audible

alarms remain active). Refer to page 19 to see this distinction.

Confirm that you wish to change the setting of the audible attention signals by

pushing .

"On" or "off" starts to flash.

2. Switch between "on" or "off" by pressing .

3. Confirm the setting with .

Switching the water contacts on and off

On submerging in water the water contacts switch on Aladin

automatically

If you chose the option "Water contacts off",

Aladin

will turn on with a delay of up to 1 minute

into the

dive. This will affect functioning of the computer.

Make sure that the computer is on before starting

the dive.

Confirm that you wish to change the setting of the water contacts by pushing

"On" or "off" starts to flash.

2. Switch between "on" or "off" by pressing .

3. Confirm the setting with .

Resetting the remaining saturation

Diving after a reset of the remaining saturation may lead you into

potentially

hazardous situations which could result in death or serious injury.

After a reset of the remaining saturation do not dive for at least 48 hours.

If you dive after resetting the remaining saturation the computer will mis-

calculate your decompression, which may result in serious injury or death.

Reset the remaining saturation only if you know you will not be diving,

flying or going to higher altitude for the next 48 hours.

Resetting the desaturation should only be done when there is a valid reason,

e.g. loaning the computer to somebody who has not dived in 48 hours or

more. When the computer itself has remaining saturation you must assume full

responsibility for the consequences of resetting the remaining saturation.

Confirm that you wish to reset the displayed saturation by pushing .

"On"

starts to flash.

2. Switch between "on" or "off" by pressing .

3. Confirm the setting with . If you have selected "off", "Code" and "000"

appear.

Set the first digit by pushing and

. Confirm with

Repeat point 4 for the next 2 digits. If you entered the right code the desaturation

will be reset to zero (desat off)

Code: 313

WARNING

DESAT

Setting the backlight duration

Confirm that you wish to change the duration of the backlight illumination by

pushing .

The value starts to flash.

2. Change the duration with

. (2-12s or push on / push off)

3. Confirm it with

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 53 54

Comments to this Manuals

No comments

Uwatec Aladin 2G User Manual Page 47

Comments to this Manuals

Related products and manuals for PC/workstation barebones Uwatec Aladin 2G