Uwatec Aladin Pro Nitrox Technical Information download pdf (Page 89)

VII Interface

The Aladin

Pro Nitrox is able to communicate with a personal computer. The connection is established by

contact sensors. A special interface cable and the necessary PC-software DataTrak/DataTalk (MS-DOS) is available

on the market. Communication via interface has a number of advantages:

1.1 Personal programming of the dive computer

Several parameters can be set individually by the user, e.g.:

– The partial pressure of oxygen can be adjusted between 1.2 and 1.95 bar.

– The physical units of water depth and tank pressure can be selected (metric/imperial).

– The attention message acoustic signals can be switched off if desired (see pgs. 32, 33). The actual attention

messages shown on the face of the Aladin

Pro Nitrox are not affected by the acoustic signal being

switched off. (The acoustic messages for alarm cannot be switched off. Alarm messages are: not enough

gas mixture for safe ascent, ignoring decompression stop, making too rapid an ascent, exceeding CNS O

limit).

ppO

max must not be set higher than 1.6 bar

If you switch off the acoustic attention buzzer of the Aladin

Pro Nitrox you must

pay careful attention to the visual signals on the face of the Aladin

Air X Nitrox.

Failure to follow all alarms whether audible or not may lead to serious injury or

death due to decompression sickness, and/or drowning.

1 Interface

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 100 101

No comments

Uwatec Aladin Pro Nitrox Technical Information Page 89